How to make the installation of a heated floor?
You do not need to call specialists to install a heated floor, you can do it yourself if you have some skills and know the stages of work.
First of all, you will need a smooth and clean surface, if alignment is required, then make a tie. Typically, a warm floor is mounted on the part of the floor of the room where there is no furniture, as this allows you to save electricity. If you don’t want to do the installation yourself, then the masters of the company ABC will do everything for you http://www.azbukao.ru/services/montazh-teplogo-pola.
And now we will describe in more detail the stages of installation of a heated floor.
Installation of insulation. If you have a flat floor, then the insulation can be laid directly on it. Insulation is required in cases where the room under the floor is not heated or you install a warm floor on the first floor. Here it is important not to lose heat, because no one wants to warm the neighbors from below or the ground. Insulating material can be corkboard, penofol, foil foamed propylene, isoflex and other materials.If you use cork slabs or similar material, they must be separated from the cable with foil. If the cable is installed under the parquet, then you need to be very careful and do not allow the cable to come into contact with the lags and the parquet.
Installation of guides or metal mesh for cable. They can also be replaced with polymer mats.
Cable installation. Before him should measure the electrical resistance of the cable, then put the cable along the guide so that it was stretched, but not stretched, pinched and not twisted. Cable lines must not intersect. Next, the cable should be connected to the network through the temperature controller according to the scheme that is attached to it.